Just the Basics for Fast Muscle Gains
There are a number of reasons why modern trainees don’t get good results in the gym. I write a lot about programming, workout ideas, and whatnot, and the fact that most lifters would be better off training with more frequency, using full-body workouts, and stop treating every single workout session as if it’s an all-out onslaught where they have to storm the muscle-building Bastille. I suppose when it comes right down to it, however, the first culprit for lack of gains is just not doing the right movements in the first place. Do your workouts consist of these movements (with free weights, I must add)?
Vertical press (overhead work)
Horizontal press
Squat
Upper body pull
Lower body pull
Loaded carry
If they do, you’re probably getting decent results even without proper programming. If, on the other hand, the majority of your sessions consist of pumping up your chest and biceps muscles (probably with machines or cable movements) then it’s likely that you haven't seen results after you moved past the “newbie” stage.
Yep, exercise selection really is that important. Now, ideally, you would also combine the correct movements with good programming. If you’re new to training—or, heck, if you’ve been training half your life—you just can’t go wrong with old-fashioned full-body workouts done 3 days per week. It’s been around for a long time because it’s worked for a long time. You can’t find a single great bodybuilder from the “silver” or “golden” eras of bodybuilding’s yesteryear that didn’t start their journey to muscle-building immortality with full-body workouts. Some of them—Clancy Ross, Steve Reeves, John Grimek, Reg Park—trained their entire career with little (or nothing) else.
In addition to the correct movements and full-body workouts, use a set/rep combination that has proven successful. For each lift, if you’ll do somewhere between 15 and 25 reps, you’ll get great results. This means you just can’t go wrong with these:
3 sets of 5
5 sets of 3
3 sets of 8
5 sets of 5
Some lifters will do better at the lower end of the spectrum by sticking with 15 reps (3x5, 5x3) and others at the higher end (3x8, 5x5). That will take a little bit of experimenting. Start with the 15-rep combinations to begin with. After a month or so of training, if you think you might need it, move closer to 25.
Here’s a good full-body program that you can start with:
Squats: 5x3
Military presses: 5x3
Stiff-legged deadlifts: 5x3
Bench presses: 3x5
One-arm dumbbell rows: 3x5 (each arm)
Farmer walks: 2 to 3 sets, hard but not all-out
Train Mondays, Wednesdays, and Fridays or any other 3 non-consecutive days per week. Use a weight on each movement where the last set or two are “hard” but you can still get all of your reps on each set. Stick with that weight until the workouts start to feel “easy” and then, and only then, add some weight. This is what I often call the “everything moderate” approach and it works better for almost any lifter out there than the train-as-hard-as-you-can until you’re blue-in-the-face model. It’s what all those aforementioned old-school bodybuilders did. It worked then. It works now.
If you’re more advanced, and have already been doing workouts like that, and you want to get really big and strong then you can do more sets of roughly the same reps. In this case, move your total reps per lift to between 30 and 40. 6 to 8 sets of 5 reps is a game changer for most lifters in search of a combination of size and strength. 10 sets of 3 works well, too.
If you reach the point in your training that you’re ready for this more advanced route, you might want to consider a “full-body split.” Do 2 different workouts and rotate back and forth between the two, training every-other-day. Here are the kind of sessions I have in mind:
Workout A
Squats: 8x5
Military presses: 8x5
Wide-grip weighted chins: 10x3
Workout B
Sumo deficit deadlifts: 10x3
Bench presses: 8x5
Farmer walks: 3 to 4 sets, once again hard, but leave a little something “in the tank.”
When doing 8 to 10 sets on a movement, select a weight where you could get double the reps if you were going for 1 all-out, hard-as-heck set. So, for 8 sets of 5 reps, select a weight where you could get 10 reps. For 10x3, select a weight where you would get 6 reps. Once again, stick with that weight until all of your sets feel easy (the last couple of sets for each movement will probably be hard when starting out; this indicates you selected the correct poundage), and then add weight. It’s adding weight naturally, and it’s another key to long-term progress.
What if, for some reason, you can only use 3 movements for a program? Perhaps you’re short on time or you’re an athlete who invests a lot of energy in another sport, such as a football player or a fighter. In this case, I don’t think you can go wrong with these 3 movements:
Vertical press
Squat
Quick lift
The quick lift is good because it’s both a lower and an upper body pull. (It’s also just great for athletes in general.) It’s also a lot easier on your nervous system than deadlift variations, and your lower back recovers from it much faster, whether its power cleans, power snatches, or high pulls. The squat is always good for everyone. And if you have to choose between the two different upper body presses (horizontal or vertical), go with the vertical. For athletes it’s superior because you’re doing it standing. Standing movements, even for casual gym-goers, are almost always better than ones performed sitting or lying down.
It might seem almost too basic for a lot of trainees, but to give you an example, an MMA fighter simply couldn’t go wrong with this workout performed 3 (or perhaps just 2) days per week:
Squats: 5x3
One-arm dumbbell overhead presses: 5x3 (each arm)
Power cleans: 5x3
You can also apply all of these fundamental movements to your workouts even if you’re an older lifter, are only interested in “getting in shape,” or train at home with minimal equipment. Let’s say that you have a couple pairs of kettlebells (perhaps a pair of 30s and a pair of 50s) and nothing else. Fine. Good, in fact. Sometimes, as I’ve pointed out elsewhere, the more options that you have—such as the plethora of machines and other equipment at a commercial gym—the worse your results. There are just too many choices in that instance, and lifters don’t know where to even start. (Or they don’t know if they haven’t read, and applied, the information here.) In this case, you might do a workout like this with said kettlebells:
Double kettlebell front squats: 30 to 50 reps total (something such as 3 to 5 sets of 10 reps or 2 sets of 20)
Double kettlebell overhead presses: 30 to 50 reps total
Double kettlebell cleans: 30 to 50 reps total
Push-ups: 30 to 50 reps total
Chins: 30 to 50 reps total
Double kettlebell farmer walks: 2 to 3 longer distance sets (These are more “corrective” than anything else, unless you’re going to buy a pair of “monster” ‘bells. Still, a long stroll with a pair of 50s—or even just 30s—will do the body some “good.”)
If anyone reading this doesn’t get good results from the workouts—assuming they do them as written—then it’s probably for one reason. But this is one of those “big” reasons for not getting results out of any program. Lifters that don’t see results don’t strive to master these basic lifts. Your squats should be deep—ass-to-the-grass, as I like to say. Your bench presses should involve your butt and your head staying on the bench. Your presses—benching movements and overhead presses—should press up in a straight line and seamlessly. If one arm locks out before the other, then it’s not seamless, folks. Your grip should stay strong on your deadlifts and other pulls, and you should never drop the bar at any point. No one likes that jackass in the gym that drops the weights—usually while screaming and grunting in an attempt to “impress the ladies.” Sorry, they’re not impressed. Nope. They think that person is worse than my words of “jackass”. More like a total ass. Don’t be one of “those” guys. Master the lifts instead. Your muscles will thank you.
If you enjoyed this essay, then you will probably like my book Ultimate Mass and Power Essays. You can find more information about it, and all my other books, at the My Books page of the blog.
As always, if there are any questions or comments about the subjects discussed here, leave them in the “comments” section below. You can also send me an email if you prefer private correspondence. I usually get around to answering my emails within a couple of days.
Definitely agree newbies and really everyone should be doing bang for your buck proven movements. Always see beginners without much muscle mass or power doing more 'finesse' type bodybuilding movements, when they should be trying to get relatively strong on a heavy chest/back/quad/ham movement. And I say this as primarily a bodybuilder (who also wants to be as strong as he looks), you need a big base of muscle and power before those finesse movements show their true worth (e.g. Being able to get more triceps volume from pushdowns instead of inducing joint strain by doing even more sets of heavy pressing to get that stimulus)
ReplyDeleteAlso gotten noticably bigger and stronger on a 'everything moderate' 3 day full body-split. 5x3 is a fun rep scheme especially, I've been using it recently to go a touch heavier, especially on one-arm DB pressing (Seems like a way to still DB press while not having to clean 2 heavy bells off the floor due to just being safe with the lower back for now.) Iirc, Sig Klein circa an article from the 1930s said that era regarded anyone as strong if they could one-arm DB press 90 lbs. Should be interesting to see how strong my DB bench is when I go back to it many months later, especially as a very shoulder/tricep dominant bencher.
There's definitely a place for "finesse" training, to use your words. But most lifters do it long before they have any business doing so. After you've built plenty of mass THEN they can be quite helpful for a number of lifters. You really do have to build a mass of granite before you can chisel it. No use in chiseling a little twig.
DeleteI'm glad the "everything moderate" approach is working well for you. I think one-arm dumbbell overhead presses really are one of the best movements you can utilize, and just heavy dumbbell training in general, though that movement is definitely one of the best. Dumbbell movements always helped my bench press when I was powerlifting, too. There's just something about the way that it works all those stabilizer muscles that translates over to bigger barbell lifts. And one-arm DB presses should absolutely help your DB bench.
Thank you very much for sharing your knowledge for free. Do you have any recomendation wich set/rep scheme to use for training twice a week for the full body routine? Greetings from italy!
ReplyDeleteItaly, for 2x per week training, just stick with one of the set/rep ranges above, so 3x5, 5x3, 3x8, or 5x5. Use a handful of movements just as outlined above. When training only twice weekly, you MIGHT want to add a bit more work - a couple more sets, an additional exercise or two - but don't do that at first. See how your body responds to the initial routine and then, and only then, add more work if you feel as if you need it.
DeleteYou can also try something like the program in my "Lift Big, Eat Big, Rest Big, Grow Big" article from January if you need something more specific and regimented. It's quite "intense," however, but will definitely bring about gains with only 2 days of training if you do it as prescribed.
Good luck with your training. Let me know if you need any more info/advice.