Skip to main content

Prime and Pump Leg Training


PRIME time for sliced Hams and PUMPED quads!

by Jared Smith


How a person trains can tell you a lot about that person. There are always the guys and gals who only train the “beach” muscles and seldom pay attention to the really important things such as legs and back. You can also tell when someone has spent too much time doing the “more bang for your buck” movements without properly preparing themselves for it. I have fallen victim to the same thing in the past. I was so excited to get under the bar that I all but ignored the preparation aspect of training, and, after a while, I started feeling the effects. I have no intention of being that old man who still packs a little muscle, yet can hardly get off the toilet without the joints sounding like someone pouring milk over a bowl of Rice Crispies! There is a way to keep pounding at the king of all exercises while preserving your knees and hips—and I will show you how.
If you have read the previous installments of Prime and Pump, you know that I am an advocate of pumping  antagonistic muscles to get the connective tissues pliable and ready to train hard. With leg training it is no different. We will start our session by getting those knees and hips ready for the assault in the squat rack. The first exercise will be lying leg curls. These will be done in two different variations. The first three sets will be done with a "piston-like" cadence while you elevate your torso off the pad, thus putting your hips in a slight position of extension. Perform three sets of these for 10-12 reps. At the top of each rep, you will feel a slight tug at the very top of your thigh, and that’s exactly what you want. The next three sets will be done in the "traditional style", keeping your torso on the pad and trying to push your hips through the apparatus as you curl upward. Lower the weight slowly and squeeze at the top for a count of two. After your third set of 8 reps, it is time to move on. 
One often-overlooked and neglected preparatory measure is making sure that the calves are limber enough to allow for one to keep his or her heels glued to the floor when squatting. We will accomplish this while simultaneously prepping our lower backs for the squat. Start by placing two ten-pound plates on the floor, at around shoulder-width. We will use these to elevate our toes and perform straight-leg deadlifts. By elevating the toes, you will place the calves under a stretch, and semi-stretch the hamstrings, thus recruiting them more than with the traditional version. Make sure that you descend slowly, and initiate the concentric by contracting your hamstrings. The descent should be deliberate, and you should attempt to touch your backside to the wall behind you. Push back with your hips, then push through with them. This will really get your hamstrings "firing", and your lower back should be warm and ready to go after three sets of 10-12 reps.
Now we are ready to get down to business! After a couple of warm up sets to get the nervous system kicking in, we will pound out four sets of squats. Imagine trying to pull yourself to the floor with your hamstrings. This will  keep your descent slow and controlled. The concentric shouldn’t be explosive. We are trying to squeeze the muscle as if it owes us money, even though it's a compound movement. We are after hypertrophy, pure and simple. After four sets of 8-10 with only a minute of rest between sets, you should feel pumped.
Next up, we have leg presses. If you think that since squatting is done the hard part is over, you are very sadly mistaken. We will do seven “doubles” as I call them. (These will be far less enjoyable than a double you would order from the local bar tender.) The first half of each set will be done with a narrow stance for ten reps, the second half will be done with a wide stance for another ten. We are essentially cramming 14 sets into a very short period of time. Rest only 40 seconds between each double, and keep the tempo smooth and piston-like, with no stops at the bottom or top of the movement. 
Next on the agenda will be drop-set leg extensions. These will not be the traditional drop sets you might be used to. These will be mechanical drop sets. This means we will do a more difficult version of the lift first, then, keeping the weight the same, we shift our “mechanical” advantage and continue repping out. The first part of the set will be done with your chest held up high, and a slight forward lean off the back pad, allowing your torso to be at exactly 90 degrees to the thigh, thus shortening the quad from both the hip and the knee. When you reach failure, lean back against the pad which will place the muscle in the midrange where it is strongest. Continue the set until you fail again. Three rounds of this torture, with a minute rest in between, with a controlled negative and a two-count squeeze at the top of each rep, and that is all she wrote!
By this point, your legs should be pumped and, if you pushed your sets to failure, you should be feeling a little shaky—perhaps even a bit nauseous. If you feel like death warmed over, I applaud you for a job well done! 
     Stay tuned for the next installment of Prime and Pump, where I will carve out your path of destruction through a back/triceps workout that will get you grabbing attention even when your back is turned to the “cardio bunnies”!


Comments

  1. Jared-

    Another great read. I like the fact that your trying to present "getting big with a brain", ie- training for max hypertrophy without needing surgery 10 years down the road. Only problem is all your damn articles are making me want put the singlet in the closet and train for a bodybuilding show!

    ReplyDelete
  2. Jason, I agree, man.

    Even though power training is my "addiction", I must say that I wish I had done more of Jared's kinder—but in no friggin' way gentler—training when I was younger, and even when I was competing in powerlifting. In fact, at the very least, you may want to give Jared's programs a "go" immediately AFTER your next powerlifting meet for around 4 to 6 weeks.

    I don't think it would hurt, and your body might very well thank you 10 years down the road (or more).

    ReplyDelete
  3. Thank you both for the feedback! It is awesome to know that folks are getting something out of the articles. I can't thank C.S. Sloan enough for giving me the opportunity to share some of what I've learned on here even if some of it does border on fringe science.

    ReplyDelete

Post a Comment

Feel free to leave us some feedback on the article or any topics you would like us to cover in the future! Much Appreciated!

Popular posts from this blog

The 5x10x5 Program

A HIgh-Frequency Muscle-Building Routine So Simple That It Seems Almost Too Good to Be True      A few years ago, after suffering from some herniated discs that were causing me pain, I experimented with a program so simple that I wasn’t sure it would work.  I should have known better.  After utilizing it, and getting good results, I thought it was even too simple to write about.  Readers might think I had gone off the deep end.  But I didn’t.  And I haven’t.  I’m currently using the program right now, after taking a week-long layoff in order to prepare myself for a “bigger” program a few weeks down the road.      Before using this program, I had already had a lot of success with easy strength methods.  I write about them quite a bit, so, unless this is your first time reading one of my articles, you’re already well-aware of the methodology.  With easy strength, you, typically, do no more than 10 r...

Load Cycling

The Principle for Programming High-Frequency Workouts      I know that I’m probably beating the proverbial dead horse here, seeing as how I have gone on more than a few rants on the subject, but the main problem, as I see it, in modern training circles is the all or nothing mentality .  The training culture in America—I have the distinct feeling that it’s no different for my international readers—is one where we think a workout is “good” if it exhausts or fatigues you.  If you’re lying in a pool of sweat once the workout is finished, and the next day your muscles are sore to the bone, then, by God, it must have been an effective training session.  Unfortunately, it just doesn’t work that way.  And if you’re chasing strength and power along with muscle mass, that method will fail you.       “If you want pain, learn Muay Thai. If you want to learn about failure, play golf. If you want to vomit, drink a syrup of ipecac...

More on Load Cycling

       In my previous article, I presented a basic program, for building both mass and strength, that demonstrated how you can best utilize load cycling.  The premise is simple, but it’s the key to making consistent gains.  You start with a lighter load and do workouts where you are not taking any of your sets to failure, or approaching failure, really.  Then, you increase the load from week to week until you reach the point that you are approaching failure.  When you reach that point in the program, you back off again and repeat.  This method has been used by various strength athletes—powerlifters, Olympic lifters, and the like—for decades in order to produce consistent gains.      In this essay, I want to look at some varied ways to make this principle work.  We’ll also look at some different programs.      This principle is more important than most lifters realize.  It’...